Chapter 44-10Base MF6560PL / / LaserBase MF6580PL1) Remove the pickup/feed roller unit.2) Remove the screw [1], and then remove the roller bracket [2].3) Remove the pickup roller [3].F-4-244.4.7 Feed Roller4.4.7.1 Removing the Feed Roller 0011-5236LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-Base MF6560PL / / LaserBase MF6580PL1) Remove the pickup/feed roller unit.2) Remove the screw [1], and then remove the roller bracket [2].3) Remove the feed roller [3].F-4-254.4.8 ADF Motor4.4.8.1 Removing the ADF Motor 0011-5250LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-Base MF6560PL / / LaserBase MF6580PL1) Remove the feed frame unit.2) Remove the two screws [1], and then remove the drive unit [2].F-4-263) Remove the two sensors [1] (by releasing the claws), two leaf springs [2](one screw each), two solenoids [3] (one screw each), one E-ring [4], andthree gears [5].F-4-274) Remove the two gears [1] and three screws [2], and then remove thebracket [3].5) Remove the clamp from the motor frame. The remaining part is the ADFmotor unit [4].F-4-28Since the ADF motor unit was factory-adjusted, do not disassemble it fur-ther.After replacing the ADF motor unit, reinstall the parts removed in steps 3)and 4).4.4.9 Document Set Sensor4.4.9.1 Removing the Document Set Sensor 0011-5254LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-Base MF6560PL / / LaserBase MF6580PL1) Remove the rear cover.2) Remove the connector [1], release the hook, and then remove thedocument set sensor [2].F-4-29[1][3][2][1][3][2][1][2][1][1] [4][5] [5][2] [3][3][1][2][2] [4][3][2][1]