2-16 Setting Up Chapter 28 Start with the Yellow BJ tank.Remove the packing film by pulling onthe orange tape q. Then grip thebottom of the BJ tank and twist off theorange protective cap in the directionshown w.• Carefully remove the packing film taking carenot to remove the label from the BJ tank.• Discard the packing film and cap. Neverattempt to reattach them to the BJ tank.• Do not touch the ink port on the BJ tank.• Spilled ink can stain any surface; protectyourself and your work area.9 Insert the Yellow BJ tank into the farright slot on the BJ cartridge, thenpress it down from the top until itclicks into position.10 Repeat steps 8 and 9 to install theMagenta BJ tank, then the Cyan BJtank, and finally the Black BJ tank. Besure to install them in this order andto insert them in the slots from right toleft.• Do not use the BJ cartridge with any of itsBJ tanks missing as this can cause the BJcartridge to clog.11 Close the printer cover.• The LCD displays CART. RETURN while the cartridge holder moves to its home positionon the right side of the unit. The MultiPASS then cleans the print head which takes about20 seconds.12 Close the document tray.nIf you need to unplug the MultiPASS, wait until the unit is in standby mode (date andreceive mode displayed in the LCD). Otherwise the cartridge holder may not be in its homeposition causing the BJ cartridge to remain uncapped and dry out.Made in Japan Made in Japan Made in Japan Made in JapanPUSH PUSHPUSH PUSHInk TankBCI-3CInk TankBCI-3MInk TankBCI-3YInk TankBCI-3BKBlack Cyan Magenta YellowYELLOWMAGENTACYANBLACKInkTaBCI-YellowMade in JapanPUSHInkTankBCI-3MYellowMade in JapanPUSHPUSHTO PREVENT INK SPILLS, DO NOTPRESS THE SIDES OF THE BJ TANK.12
