CHAPTER 11 TROUBLESHOOTINGCOPYRIGHT © 1997 CANON INC. CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON) 11-185D. Sorter Self Diagnosisn Resetting the Errors1. If the copier is in the middle of operation,q It turns on the “Jam indicator”.w Turn off and on the power switch removing the jam.e The copier runs a self check. It is reset if the result is good. If the result is not good,it enters down state*, indicating ‘E5XX’; on the control panel.2. If the copier is not operating,q Jam indicator indicates.w When the power has been turnd off and then on again, it runs a self check. it is resetif the result is good. If the result is not good, it enters down state*, indicating ‘E5XX’;on the control panel.• Down Stateq It indicates ‘E5XX’.w When the sorter has been detached**, it is ready for operation unless a moderequiring the sorter is selected.n The copier will be reset if the result of a self check after the power has been turnedoff and then on again is good even in down state. (This is with the sorter connectedto the copier.)* State in which an error code is indicated.** Turn off the joint sensor. The connector may remain connected.Code Cause•CPU or communication ICon sorter controller (faulty)•Feeder motor (fails to rotate)•Stapler guide bar swingmotor (fails to rotate)•Stapler unit swing motor(fails to rotate)•Bin shift motor (fails torotate)•Bin motor (faulty)•Lead cam drive gear (wronginstallation)TimingAn error has occurred in thecommunication between the sorter andthe copier.The clock signal from the motor remainsoff for 250 msec.The home position sensor does not turnoff when 2560 pulses of the motor drivesignal have been generated.•The stapler unit swing sensor does notturn off within 500 msec after the motordrive signal has been generated.•The stapler unit swing sensor does notturn on within 1000 msec after it hasturned off.•The lead cam home position sensordoes not turn off within 2000 msec afterthe motor drive signal has beengenerated.•The lead cam home position sensordoes not turn on within 2000 msec afterit has turned off.The lead cam position sensor does notturn on within 1.0 sec after it has turnedoff.E500E510E530E531E540E541Download Service Manual And Resetter Printer at http://printer1.blogspot.com