Cut to standard sizeSpecifies standard size as the output page size when printing on roll paper.Select this setting item from Device settings > Print settings > HP-GL/2 print settings > Paper settings.• If OFF (Initial setting) is selected:Cutting according to standard size is not performed.• If ON is selected:Cuts to standard size in accordance with the roll paper width.When there are two lengths/widths applicable for a given roll paper width, the optimum size is selectedautomatically.Note• Nesting cannot be performed while ON is selected.• If ON is selected for Conserve paper and there is blank space above/below the image, the size willnot be standard size.• When ON is selected for Print centered, printing will be in the center of the standard size.• If there is no standard size corresponding to the roll paper width, operation is the same as if OFF isselected. No message is displayed.• When there are multiple width/length candidates in the roll 1 (upper) and roll 2 (lower) in a double-roll printer model, the optimum standard size is selected automatically under the followingconditions.• When any of the candidates accommodates the output page size, the standard size closest tothe minimum image range is selected for efficient printing.• When none of the candidates accommodates the output page size, the largest standard size isselected to expand the print range.• For information about supported standard sizes, see the appendix at the back of this manual.STANDARD CUT EXAMPLES• A3-size width roll paperA. Position of cut when OFFB. Position of cut when ON• A3-size width roll paper246
