Canon VB-C60 Operation Manual

Also see for Vb-C60 - Ptz Network Camera: Setup guide Operation guide Setup guide Administrator's manual Administrator's manual

Contents

1-16▼Day/Night1 ModeSelect the switching mode from “Manual” and “Auto”. When specifying “Auto”, you can set“Switching Brightness” and “Response” according to the environment where the camera isinstalled or the switching condition.* If you are using an infrared lamp, you cannot use “Auto”.2 Switching BrightnessSelect the brightness level to switch day mode and night mode from “Darker”, “Slightly Darker”,“Standard”, “Slightly Brighter” and “Brighter”. When you prefer to shoot color video as muchas possible, select “Darker”. When you prefer to reduce noise even in black and white video,select “Brighter”.3 Response (sec.)Select the time, at which day mode and night mode switches, from “5”, “10”, “20”, “30” and“60”. The day and night mode are switched when the brightness set in the above 2, maintainsfor a set period of time. It is recommended to specify “30” or “60” for situations, where thebrightness frequently changes, for example, light sources pass in front of the camera. Or,specify “5” or “10” for situations, where there are few changes in brightness.Set the Camera Control and External Device Names (Camera)2 Image StabilizerSelect whether or not to activate Image Stabilizer from “Disable”, “On1” and “On2”. ImageStabilizer effectively works to compensate for image blur caused by camera shake. If “On1” isnot strong enough to correct the image blur, try “On2”. While Image Stabilizer is being activatedwith “On1” or “On2”, the viewing angle may be narrower and the image quality may be degraded,comparing with when Image stabilizer is disabled. This is because of the stabilization process,not camera failure.Approx. 80,000 pixelsBlur Level Ratio of viewing angle No. of effective pixelsDisable _ 100% Approx. 310,000 pixelsOn1 Small 83% Approx. 210,000 pixelsOn2 Large 50%Note● It is recommended to set the image capture size to “320 x 240” or smaller, whilespecifying “On2”.● IS does not work to correct vibration of a subject itself.● Image Stabilizer cannot correct image blur caused by instantaneous shake or largevibration that exceeds a certain level.● Refer to P.3-20, for note on viewer use while Image Stabilizer is being activated.121211212212123COPY