2-16Maximum left/right captured areaTilt controllable areamaximum up/down capture areaMaximum wide-angle viewing anglePan controllable areaNote● When changing settings for camera’s installation conditions, you need to recapturea panorama image and register again.● Panorama Preview may be slightly different from the actual picture. You need tocheck if the view restrictions are correctly reflected in VB Viewer after the viewrestrictions have been set.● You should use VB Viewer when confirming the setting. (view restriction is notapplied in Admin Viewer.)● If changing the setting of Image Stabilizer after View Restriction settings, the viewrestriction area may be different between when it is set and when it is actually used(→ P.3-20).● When changing Image Stabilizer or Digital Zoom setting, you need to reconfirmthe view restriction.Tip● Even when view restriction is set, if the camera is controlled to capture near theboundary of the view restrictions, the restricted area may be momentarily captured.● To release view restriction, clear the “Apply the view restriction” check box andthen click “Apply” and “Save View Restriction”.● When the value is blank while “Apply the view restriction” is checked, the maximumview restriction value is used.● The controllable area and captured area are as follows:View Restriction ToolCOPY
