Cutting the Leading Edge of Roll Paper AutomaticallyIf the leading edge of a roll is crooked or warped, it may cause an error message or printing problems. In this case, setTrim Edge First to Automatic or On on the Control Panel to have the printer cut the leading edge to make the edgestraight after you load a roll.Trim Edge First offers the following options.• AutomaticIf the left and right side of the leading edge of the roll ((a) and (b)) are uneven by 40 mm (1.6 in) or more whenyou load the roll, the edge is cut an amount relative to the slant to ensure a straight edge, and scraps are removed.The edge is not cut if the unevenness is less than 40 mm. However, paper may sometimes be cut, depending on thestate of the leading edge.• OffThe edge is not cut and scraps are not removed. This setting is Off for most types of paper, by default. For moreinformation, see the Paper Reference Guide. (See "Types of Paper.") →P.578• OnThe leading edge is cut off when you load a roll, and scraps are removed. The amount of paper cut off from theleading edge varies depending on the paper type. For more information, see the Paper Reference Guide. (See"Types of Paper.") →P.578Note• If you print on paper that has an irregular width, set Skew Check Lv. to Loose for a higher skew detec-tion threshold or to Off to disable skew detection. However, if paper is loaded askew when detection isOff, note that paper jams or Platen soiling may occur.Follow these steps to change the Trim Edge First setting.1. Press the Menu button to display MAIN MENU.2. Press ▲ or ▼ to select Paper Details, and then press the ▶ button.Handling Paper > Handling rolls >iPF825 Cutting the Leading Edge of Roll Paper Automatically7611
