Cause Corrective ActionThe roll width set in Fit Roll Paper Width in theprinter driver does not match the width of the rollloaded in the printer.Hold down the Stop button for a second or more to cancelprinting.Make sure the roll width selected in the dialog box dis-played when you select Fit Roll Paper Width in the print-er driver matches the width of the roll loaded in the printer,and then try printing again.Paper size not detected.Cause Corrective ActionPaper has been loaded askew, or warped paper has been loaded. Follow these steps to reload the roll.1. Lift the Release Lever.2. Open the Top Cover.3. Adjust the right edge of the roll to make itparallel to the right Paper Alignment Line.4. Lower the Release Lever.5. Close the Top Cover.6. If "Not finished printing. Finish printingremaining jobs?" is shown on the DisplayScreen, press the OK button.Printing will resume, starting from thepage on which the error occurred.(See "Loading Rolls in the Printer.")→P.588If this error recurs after you reload the roll, re-move the Roll Holder from the printer, pushthe roll firmly in until it touches the RollHolder flange, and reload the Roll Holder inthe printer.(See "Attaching the Roll Holder to Rolls.")→P.584Follow these step to reload a sheet.1. Lift the Release Lever.2. Open the Top Cover.3. Adjust the right edge of the sheet to makeit parallel to the right Paper AlignmentLine and the trailing edge of the sheet tomake it parallel to the paper alignment lineunder the Paper Retainer.4. Lower the Release Lever.5. Close the Top Cover.6. If "Not finished printing. Finish printingremaining jobs?" is shown on the DisplayScreen, press the OK button.Printing will resume, starting from thepage on which the error occurred.(See "Loading Sheets in the Printer.")→P.616Error Message > Messages regarding paper >iPF825 Paper size not detected.13825
