Roll Holder SetLoad a roll on the roll holder and then load the holder in the printer. The Roll Holder in the Roll Holder Set RH2-44 isfor use with both 2-inch and 3-inch paper cores. Use the correct attachment for the particular paper core. (See "Attach-ing the Roll Holder to Rolls.") →P.584• Roll Holder Set RH2-44• Roll Holder (for 2- and 3-inch paper cores)• AttachmentsUsing the 2-Inch Paper Core Attachment Using the 3-Inch Paper Core Attachment2-Inch Paper Core Attachment 3-Inch Paper Core Attachment #1 3-Inch Paper Core Attachment #2Automatic Roll SwitchingTwo rolls can be loaded on the printer, in the Roll 1 (Upper) position and in the Roll 2 (Lower) position. Selecting RollPaper (Auto) in Paper Source in the printer driver enables automatic selection and printing on the roll that suits theprint job from the loaded rolls.The printer determines which roll to use based on these conditions, in the following order.Note• If an error message is displayed, neither paper feed slot is loaded with paper suitable for the print job.Check the print job and replace the paper. (See "Removing the Roll from the Printer.") →P.5971. When ManageRemainRoll in the printer menu is set to On, the roll longer than the length of a single page ofthe print job is used.When ManageRemainRoll is set to Off and both rolls are longer than the print job, the second condition deter-mines which roll is used.Note• When the roll currently advanced is a type of paper that cannot be cut and the printed pages havenot been cut, the currently advanced roll is used.• If both rolls are too short, an error message is displayed.Handling Paper > Handling rolls >iPF825 Roll Holder Set7613
