Problems with the printing qualityThe surface of the paper is dirtyCause Corrective ActionThe Paper Retainer is soiled. Clean the Paper Retainer . (→P.673)You are using a paper that does not dry easily. Specify a time of about a minute in Roll DryingTime .The back side of the paper is dirtyCause Corrective ActionThe Platen has become dirty after borderless printingor printing on small paper.Open the Top Cover and clean the Platen .(→P.670)The Paper Retainer is soiled. Clean the Paper Retainer . (→P.673)Banding in different colors occursCause Corrective ActionThe roll is not loaded correctly in the Roll Feed Unit. Remove the roll and reload it.(→P.118)The paper feed amount is not adjusted correctly. Adjust the feed amount.(→P.615)Printing does not proceed smoothly because printjobs are interrupted during transmission.Exit other applications and cancel other print jobs.In the printer menu, Print Length is specied inFeed Priority .To adjust the feed amount, specify Band Joint inFeed Priority in the printer menu.(→P.615)The Printhead is out of alignment. Adjust the Printhead alignment.(→P.610)Streaks may occur if you set the Print Quality toolow.Choose a higher level of Print Quality in theAdvanced Settings of the printer driver and tryprinting again.(→P.203)The contrast becomes uneven during printingCause Corrective ActionThe paper feed amount is out of adjustment. Execute Adjust Band during printing.(→P.615)700 Troubleshooting
