Protocol Settings 5-35Using a NetBIOS Network (Windows)Protocol SettingsYou can specify the protocol settings for the machine using any of the following:• Control panel• NetSpot (Utility software provided with the machine)• Web browser (Remote UI)IMPORTANT• When configuring the TCP/IP settings for the first time, use the control panel of thismachine or NetSpot. After configuring the settings, you can change the content by usinga web browser (Remote UI).NOTE• For instructions on entering settings using NetSpot, see “Chapter 7 Using the Networkand Device Settings with NetSpot.”• For instructions on entering settings using a web browser (Remote UI), see “Chapter 2Functions of the Remote UI” in the Remote UI Guide.Settings from the Control PanelIMPORTANT• Settings specified from the control panel become effective after the machine is restartedafter the procedure.• For information on entering characters using the touch panel display, see “Chapter 1Before You Start Using This Machine” in the Reference Guide.TCP/IP Settings1 Specify the TCP/IP settings.If you have not entered the TCP/IP settings yet, enter them now (see “TCP/IPSettings,” on p. 3-4 in “Chapter 3 Using a TCP/IP Network (Windows/ UNIX/Macintosh)”).Next, specify the SMB and WINS settings.
