Protocol Settings6-4Using an AppleTalk Network (Macintosh)6Protocol SettingsYou can specify the protocol settings for the machine using any of the following:• Control panel• NetSpot (Utility software provided with the machine)• Web browser (Remote UI)IMPORTANT• To configure settings with software other than the control panel of the machine orNetSpot, TCP/IP protocol must be supported by your network environment. The followingprocedures describe sample settings using the control panel.NOTE• For instructions on entering settings using NetSpot, see Chapter 7 “Using the Networkand Device Settings with NetSpot.”• For instructions on entering settings using a web browser (Remote UI), see “Chapter 2Functions of the Remote UI” in the Remote UI Guide.Settings from the Control PanelIMPORTANT• AppleTalk is available only on Ethernet. You cannot use AppleTalk on Token Ring. Whenthe Token Ring board is installed on the machine, you cannot use AppleTalk. Remove theToken Ring board if it is installed on the machine.• Settings from the control panel become effective when the machine is restarted after theprocedure.• For information on entering characters using the touch panel display, see “Chapter 1Before You Start Using This Machine” in the Reference Guide.1 Press (Additional Functions).
