• The control temperature is determined according to the fixing mode or to the fixing temperature at the start of warm-up control.The 12 modes are provided as the fixing mode for the selected feed table and paper type.The following table is the control temperature when the fixing temperature is less than 55 deg C at the start of warm-upcontrol.Fixing mode Setting Target temperature (deg C)1-sided/first of 2-sided Second of 2-sidedPlain paper Paper type 208 203Thin paper 198 193S-thin paper 188 183Heavy paper 223 223Heavy paper-H 223 223Bond paper 223 223OHP 198 198Postcard 223 ---S-Postcard 223 ---Envelope 223 ---N1 165 165N3 155 155NOTE:Offset of fixing control temperature (High and low of control temperature)• PRINT > SW > 62Control temperature during cassette feeding• PRINT > SW > 63Control temperature in Heavy/Heavy-H/Bond paper modes• PRINT > SW > 166Control temperature for the second side of 2-sided copying• PRINT > SW > 173Control temperature for the second side of 2-sided copying• PRINT > SW > 179Control temperature in Postcard/S-Postcard/Envelope modes)0 to 2: +15 deg C3 to 11: +12 to -15 deg C (each 3 deg C) [Default: 7]12 to 14: -15 deg C■ Down sequence control● Down sequence when feeding small size paperPurpose:• To prevent temperature rise of non-feeding area in the case of continuous print of small size paper (less than A4 of lengthin width direction), fixing offset or deterioration of fixing film.Starting conditions:• The down sequence is performed step by step. When the detected temperature of sub thermistor reaches the followingtemperature or higher for 430 msec continuously, the productivity decreases every one step.Step Normal 1st step 2nd step 3rd stepShift temp (deg C) 235 245 255 275Operation:2. Technical Explanation71
