Dahua DHI-ARC3008C User Manual
Also see for ARC3008C: Installer manual
                                                  | |
Contents
| 
Alarm Control Panel User Manual142.4.2 StatusPower LED Indicator ( ) Glows: The system operates with normal power supply. Slowly flashes: The system does not operate normally due to a lack of power supply, and therefore acheck must be given. Quickly flashes: The system is in installer programming mode or on the Walk Test Zone mode. If alack of power supply occurs when the system is in either of these two modes, the LED indicator alsoquickly flashes.Battery LED Indicator ( ) Slowly flashes: Battery defects such as low power and powering off quickly. Off: Battery operates normally.Fault LED Indicator ( ) Glows: System faults (main power loss, battery low voltage or missing), and you can view the detailson the SYSTEM TROUBLES menu. Slowly flashes: Tampering is happening to the Control Panel, siren, or Keypad. Off: The system operates normally.Bypass LED Indicator ( ) Glows: There is at least one bypassed zone. Off: There is no bypassed zone.1-8 LED IndicatorsThere are eight LED indicators located below the LCD display represent the status of the Areas. From leftto right they show the alarm status of Area 1 to Area 8. See Figure 2-4.Area status LED indicatorsFigure 2-4 Glows: The Area is armed. Slowly flashes: The alarm is in progress or the alarm has occurred Quickly flashes: The Area is in alarm condition and the linkage is in progress. This conditiondisappears when the Area is disarmed. The indicator starts to flash slowly and is cancelled when avalid user code is typed in again followed by the command DISARMED. Off: The Area is disarmed.By pressing and holding the number key corresponding to each Area for three seconds, you can viewwhere exactly the alarm is in the Area. For example, when the Area 5 indicator quickly flashes, press and |
Related manuals for Dahua ARC3008C
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine