Dahua DHI-ARC3008C User Manual
Also see for ARC3008C: Installer manual
                                                  | |
Contents
| 
Alarm Control Panel User Manual19Press to do the arming.Step 4The Keypad emits a confirmation buzzer.The armed Area shows an upper case T, and the corresponding LED indicator lights up. The Areasthat are not armed continues to show a dash. You can add other Areas to the arming at any time.See Figure 3-1.If the Exit Delay is active, the Keypad keeps sounding a buzzer for the entire programmed ExitDelay period.Total armingFigure 3-13.1.2 Partition 1 ArmingPartition Arming 1 activates partial protection with part of system armed and only activates a predefinedgroup of detectors.From Partition Arming 1, you can only proceed to Partition Arming 1+Partition Arming 2, or Total Arming.To use the Partition Arming 1, do the following:Confirm that all Zones are ready to be armed, which means there must not be any * character inStep 1the place of dash in the second line of the LCD display.To identify which Zone is not ready, do the following:1) Press and hold the numeric key (from 1 to 8) where the * character appears.The first OPEN Zone shows on the display.2) Press and to scroll up and down the page to show other not ready Zones.After these Zones are identified, you can send person to do the onsite examination or go toZONE MANAGER menu to set bypass for these Zones.Enter your user code, and then press .Step 2The numbers of Areas ready for arming are shown on the second line of the LCD display.Select the Areas that need to be involved in the arming by pressing the corresponding numeric keyStep 3(from 1 to 8).Press to do the arming.Step 4The Keypad emits a confirmation buzzer.The armed Area shows the number 1, See Figure 3-2, and the corresponding LED indicator lightsup. The Areas that are not armed continues to show a dash. You can add other Areas to the armingat any time. |
Related manuals for Dahua ARC3008C
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine