Piranha4 2K and 4K Color Camera User's Manual 33Teledyne DALSA 03-032-20180-06Data connector: Camera LinkThe camera uses two Camera Link SDR26 cables transmitting the Camera Link Base, Medium, Full, orDeca configuration. The figure below shows the SDR26 Camera Link Connector and the tables that followlist the Camera Link configurations.For detailed information on Camera Link please refer to the Camera Link Road Map available from theKnowledge Center on the Teledyne DALSA Web site.Figure 23. SDR26 Camera Link ConnectorData 2 Control / Data 1CameraConnectorRight AngleFrame GrabberConnectorChannel LinkSignalCameraConnectorRight AngleFrame GrabberConnectorChannel LinkSignal1 1 inner shield 1 1 inner shield14 14 inner shield 14 14 inner shield2 25 Y0- 2 25 X0-15 12 Y0+ 15 12 X0+3 24 Y1- 3 24 X1-16 11 Y1+ 16 11 X1+4 23 Y2- 4 23 X2-17 10 Y2+ 17 10 X2+5 22 Yclk- 5 22 Xclk-18 9 Yclk+ 18 9 Xclk+6 21 Y3- 6 21 X3-19 8 Y3+ 19 8 X3+7 20 100 ohm 7 20 SerTC+20 7 terminated 20 7 SerTC-8 19 Z0- 8 19 SerTFG-21 6 Z0+ 21 6 SerTFG+9 18 Z1- 9 18 CC1-22 5 Z1+ 22 5 CC1+10 17 Z2- 10 17 CC2+23 4 Z2+ 23 4 CC2-11 16 Zclk- 11 16 CC3-24 3 Zclk+ 24 3 CC3+12 15 Z3- 12 15 CC4+25 2 Z3+ 25 2 CC4-13 13 inner shield 13 13 inner shield26 26 inner shield 26 26 inner shieldNote:*Exterior Overshield is connected to the shells of the connectors on both ends. Unused pairs should be terminated in 100 ohms atboth ends of the cable. Inner shield is connected to signal ground inside camera
