34 Piranha4 2K and 4K Camera Color User's Manual03-032-20180-06 Teledyne DALSACamera link bit definitionsSignal Configuration RemarkCC1 EXSYNC Keep this signal in low status when idle. The exposure time must not begreater than the camera’s allowance—3,000 μs.CC2 SpareCC3 DirectionCC4 SpareTable 6: Camera Control ConfigurationFor additional Camera Link documentation refer to the Teledyne DALSA Web site’s Knowledge Centerapplication notes.Camera TimingNote: Information on setting up the camera’s AOI can be found here, Area of Interest (AOI) Setup.RGB 8 bit, CL Base, maximum line rate 20 kHz (4k) and 40 kHz (2k), no AOI and 85 MHzCL clockThis timing can be used for applications that require line rates only up to 20 kHz and therefore can useCamera Link Base mode with only one cable.The RGB output format is compatible with the Camera Link specification for Base RGB. Line rates up to70 kHz can be achieved by using the Area of Interest (AOI) feature; where the smaller the AOI, thegreater the potential line rate.Red 1D0..D7Blue 1D0..D7Green 1D0..D7Red 2D0..D7Blue 2D0..D7Green 2D0..D7Red 3D0..D7Blue 3D0..D7Green 3D0..D7Red 4D0..D7Green 4D0..D7Red 4095D0..D7Blue 4095D0..D7Green 4095D0..D7Red 4096D0..D7Blue 4096D0..D7Green 4096D0..D7Blue 4D0..D7CL Port ACL Port BCL Port CCL ClockLine Valid
