46 Piranha4 2K and 4K Camera Color User's Manual03-032-20180-06 Teledyne DALSA!LVAL (high) Outputting valid lineDVAL Not usedSTROBE (rising edge) Valid dataFVAL Set to 0Power connectorWARNING: It is extremely important that you apply the appropriate voltages to your camera.Incorrect voltages may damage the camera. Input voltage requirement: +12 VDC to +24 VDC,2 Amps. Before connecting power to the camera, test all power supplies.1 65432Figure 25: 6-pin Hirose Circular Male Power Plug—Power ConnectorTable 7. Power Plug PinoutPin Description Pin Description1 +12 V to +24 V DC 4 GND2 +12 V to +24 V DC 5 GND3 +12 V to +24 V DC 6 GNDThe camera requires a single voltage input +12 VDC to +24 VDC. The camera meets all performancespecifications using standard switching power supplies, although well-regulated linear supplies provideoptimum performance.WARNING: When setting up the camera’s power supplies follow these guidelines: Apply the appropriate voltages. Protect the camera with a 2 amp slow-blow fuse between the power supply and the camera. Do not use the shield on a multi-conductor cable for ground. Keep leads as short as possible in order to reduce voltage drop. Use high-quality supplies in order to minimize noise.Note: If your power supply does not meet these requirements, then the camera performance specificationsare not guaranteed.LEDsThe camera is equipped with an LED on the back to display the operational status of the camera. Thetable below summarizes the operating states of the camera and the corresponding LED states. When morethan one condition is active, the LED indicates the condition with the highest priority.Color of Status LED MeaningOff No power or hardware malfunctionBlinking Green Powering up or calibratingGreen Ready!
