9.3.2 Connectl Connect the interface cable to a serial interface on your PC and to the serial interface X6 of theservo amplifier. USB to serial converter can be used optionally.l Switch on the 24 V power supply for the servo amplifier.l Wait about 30 seconds, until the front display of the servo amplifier displays the current classe(e.g. for 3 amps). If the power supply voltage is switched on, too, a leading P is display-ed (e.g. for Power, 3 amps).If a fault code ( ) or a warning ( ) or a status message (./_ / E/S) appearsin the display, you will find the description on page 88ff. If there is fault, fix theproblem.Double-Click the DRIVE.EXE icon on your Windows desktop to start the software.You can work offline or online with .Work ONLINE now. Select the interface where the servo am-plifier is connected to.The software tries to communicate with thedrive and to upload the parameters. If it'snot successful, you receive this error mes-sage.Frequent causes:- wrong interface chosen- wrong connector chosen at the servo amplifier- interface is used by another software- 24 V auxiliary voltage for the servo amplifier not working- interface cable broken or wrong wiringClick OK to remove the error message. Detect and remove the error source. Restart the software.76 SERVOSTAR ® 601...620 Product ManualSetup 07/2007 Danaher Motion
