Danfoss FC 300 Design Manual
Also see for FC 300: Operating instructionsInstruction manualDesign guideDesign guideDesign guide
                                                                                                                                                                                                                                                                                                                 | |
Contents
| 
Parameters: Data Read-outs16-** Data Read-outsParameter group for data read-outs, e.g. actualreferences, voltages, control, alarm, warning andstatus words.16-0* General StatusParameters for reading the general status, e.g.the calculated reference, the active control word,status.16-00 Control WordValue:0 - FFFF 0Function:View the Control word sent from the frequencyconverter via the serial communication port in hexcode.16-01 Reference [Unit]Value:-999999.000 - 999999.000 0.000Function:View the present reference value applied on im-pulse or analog basis in the unit resulting from theconfiguration selected in par. 1-00 (Hz, Nm orRPM).16-02 Reference %Value:-200.0 - 200.0 % 0.0%Function:View the total reference. The total reference is thesum of digital, analog, preset, bus, and freeze ref-erences, plus catch-up and slow-down.16-03 Status WordValue:0 - FFFF 0Function:View the Status word sent from the frequencyconverter via the serial communication port in hexcode.16-05 Main Actual Value [%]Value:0 - 0 N/A N/AFunction:View the two-byte word sent with the Status wordto the bus Master reporting the Main Actual Value.Please refer to the VLTÆ AutomationDrive FC 300Profibus Operating Instructions MG.33.CX.YY for adetailed description.16-1* Motor StatusParameters for reading the motor status values.16-10 Power [kW]Value:0.0 - 1000.0 kW 0.0kWFunction:View the motor power in kW. The value shown iscalculated on the basis of the actual motor voltageand motor current. The value is filtered, andtherefore approx. 1.3 seconds may pass fromwhen an input value changes to when the dataread-out values change.16-11 Power [hp]Value:0.00 - 1000.00 hp 0.00hpFunction:View the motor power in hp. The value shown iscalculated on the basis of the actual motor voltageand motor current. The value is filtered, andtherefore approx. 1.3 seconds may pass fromwhen an input value changes to when the dataread-out values change.16-12 Motor VoltageValue:0.0 - 6000.0 V 0.0VFunction:View the motor voltage, a calculated value usedfor controlling the motor.FC 300 Design GuideHow to Programmefactory setting () display text [] value for use in communication via serial communication portMG.33.B7.02 - VLT is a registered Danfoss trademark 229 |
Related manuals for Danfoss FC 300
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine