5.3.13 Control Cable LengthDigital in/digital outDependent on what electronics are being used, it is possible to calculate the maximum cable impedance based on the 4 kΩfrequency converter input impedance.Analog in/analog outAgain the electronics used puts a limitation on the cable length.5.3.14 Electrical Installation, Control Cables230 VAC50/60Hz230 VAC50/60HzTB6 ContactorTB5R1Regen +Regen - 83Regen12Brake Temp(NC)Anti-condensation heater (optional)(optional)91 (L1)92 (L2)93 (L3)PE88 (-)89 (+)50 (+10 V OUT)53 (A IN)54 (A IN)55 (COM A IN)0/4-20 mA12 (+24V OUT)13 (+24V OUT)18 (D IN)20 (COM D IN)15mA 200mA(U) 96(V) 97(W) 98(PE) 99(COM A OUT) 39(A OUT) 42 0/4-20 mA03+10Vdc0 VDC - 10VDC0/4-20 mA24Vdc0201050406 240Vac, 2A24V (NPN)0V (PNP)0V (PNP)24V (NPN)19 (D IN)24V (NPN)0V (PNP)27 24V0V(D IN/OUT)0V (PNP)24V (NPN)(D IN/OUT)0V24V2924V (NPN)0V (PNP)0V (PNP)24V (NPN)33 (D IN)32 (D IN)1 2ONA53 U-I (S201)ON21A54 U-I (S202) ON=0-20mAOFF=0-10V95400Vac, 2AP 5-00(R+) 82(R-) 81+ - + -(P RS-485) 68(N RS-485) 69(COM RS-485) 610V5VS801RS-485RS-48521ONS801/Bus Term.OFF-ON3 PhasepowerinputLoad Share Switch ModePower SupplyMotorAnalog OutputInterfaceRelay1Relay2ON=TerminatedOFF=OpenBrakeresistor(NPN) = Sink(PNP) = Source= ==240Vac, 2A400Vac, 2A0 VDC - 10VDC10Vdc37 (D IN) - option130BC548.11Illustration 5.52 Interconnect Diagram for D framesHow to Install VLT® AQUA Drive FC 202 Design GuideMG20Z102 - VLT® is a registered Danfoss trademark 1075 5
