Enter/Exit Programming ModeProduct Reference Guide 205Interface TypeSpecifies the current scanner interface. To access a scanner’s interface identifi-cation number, place the scanner in Scanner Diagnostic Mode and view the 7-segment FRU display (reference Chapter 2, Scale Diagnostic Mode, for moreinformation). Selections are:INTERFACE (I/F)TYPEI/F I.D.NUMBER NOT USER-SELECTABLERS-232 Standard 05 System Interface 7-segment FRUdisplay indicates 0at start-up (accom-panied by trill beepfor approx. 2 sec-onds)RS-232 Wincor-Nixdorf 12RS-232 Single Cable 20USB OEM 45IBM Port 17 04IBM Port 5B 08IBM Port 9B 23USB Keyboard 35USB-TEC 0DUSB COM 47NOTEA new scanner may have been shipped from the factory with aNull Interface (no interface type selected) to ensure systemcompatibility at installation. In this case, the correct InterfaceType programming bar code must be scanned first before thescanner can be used with a POS system.NOTEIf the scanner’s interface type must be changed, always be surethat interface configuration is the FIRST item scanned during aprogramming session. (Selecting an interface type resets ALLother configuration items to the factory default for that inter-face type.)CAUTIONGreat care should be taken to select the correct interface type,since you can cause damage to the scanner and/or POS termi-nal by attempting to change to an incompatible interface.ALWAYS make interface selections with the host cable DIS-CONNECTED.NOTEWhen an interface is selected, the scanner loads the configura-tion for that interface as the selection is made. Any customconfigurations done in the previous interface will not be carriedover to the configuration for the new interface.
