Dell Converged Enhanced Ethernet Command Reference 12553-1002115-01debug lacp 7debug lacpEnables debugging for the Link Aggregation Control Protocol (LACP).Synopsis debug lacp {all | cli | event | nsm | pdu {rx {all | interface {in | ex}tengigabitethernet slot/port} | tx{all | interface {in | ex}tengigabitethernet slot/port}}| sync | timer | trace level number}no debug lacp {all | cli | event | nsm | pdu {rx {all | interface {in | ex}tengigabitethernet slot/port}| tx {all | interface {in | ex}tengigabitethernet slot/port}}| sync | timer | trace level number}Operands all Turns on all debugging.cli Turns on command line interface debugging.event Turns on event debugging.nsm Turns on Network Services Module (NSM) debugging.pdu Turns on PDU debugging.rx all Turns on debugging for received LACP packets on all interfaces.rx interface Turns on debugging for received LACP packets on the specifiedinterface.interface tengigabitethernetSpecifies the 10 Gbps Ethernet interface.slot Specifies the slot number.port Specifies the port number.tx all Turns on debugging for transmitted LACP packets on all interfaces.tx interface Turns on debugging for transmitted LACP packets on the specified interface.interface tengigabitethernetSpecifies the 10 Gbps Ethernet interface.slot Specifies the slot number.port Specifies the port number.sync Turns on debugging for LACP sync transitions.timer Turns on debugging for LACP timers.trace level number Specifies the trace level number. The range of valid values is 1-7.Defaults By default, debugging is not turned on.CommandModesPrivileged EXEC modeDescription Use this command to enable debugging for Link Aggregation Control Protocol (LACP). Use the nodebug command to disable debugging.UsageGuidelinesTo display debug outputs on a specific cmsh session, use the terminal monitor command.
