Use ToView Card Speed View the speed of an active network card.Network AddressUAALAAView the network addresses.Job Timeout0–255 secondsSet the amount of time it takes for a network print job to be canceled.Notes:• 90 seconds is the factory default setting.• A setting value of 0 disables the timeout.• If a value of 1–9 is selected, then the setting is saved as 10.TCP/IP menuTo access the menu, navigate to any of the following:• Network/Ports > Standard Network > Standard Network Setup > TCP/IP• Network/Ports > Network [x] > Network [x] Setup > TCP/IPNote: This menu is available only in network printers or printers connected to print servers.Use ToSet Hostname Set the host name.Notes:• This setting can be changed only from the Embedded Web Server.• The host name can be up to 15 characters and can be a US‑ASCII oralphanumeric character, or hyphen.IP Address View or change the current TCP/IP address.Note: Manually setting the IP address sets the “Enable DHCP” and “Enable Auto IP”settings to Off. It also sets “Enable BOOTP” and “Enable RARP” to Off on systemsthat support BOOTP and RARP.Netmask View or change the current TCP/IP netmask.Gateway View or change the current TCP/IP gateway.Enable DHCPOnOffSpecify the DHCP address and parameter assignment.Note: On is the factory default setting.Enable AutoIPYesNoSpecify the Zero Configuration Networking setting.Note: Yes is the factory default setting.Enable FTP/TFTPYesNoEnable the built-in FTP server, which lets you send files to the printer using File TransferProtocol.Note: Yes is the factory default setting.Understanding the printer menus 61
