Use ToView Address Show the assigned AppleTalk address.Note: The address can be changed only from the Embedded Web Server.Set Zone[list of zones available on the network]Provide a list of AppleTalk zones available on the network.Note: The factory default setting is the default zone for the network. If nodefault zone exists, then the zone marked with an asterisk (*) is the defaultsetting.Standard USB menuUse ToPCL SmartSwitchOnOffSet the printer to automatically switch to PCL emulation when a print job receivedthrough a USB port requires it, regardless of the default printer language.Notes:• On is the factory default setting.• When set to Off, the printer does not examine incoming data. The printer usesPostScript emulation if the PS SmartSwitch is set to On. It uses the defaultprinter language specified in the Setup menu if the PS SmartSwitch is set toOff.PS SmartSwitchOnOffSet the printer to automatically switch to PS emulation when a print job receivedthrough a USB port requires it, regardless of the default printer language.Notes:• On is the factory default setting.• When set to Off, the printer does not examine incoming data. The printer usesPCL emulation if the PCL SmartSwitch is set to On. It uses the default printerlanguage specified in the Setup menu if the PCL SmartSwitch is set to Off.NPA ModeOnOffAutoSet the printer to perform the special processing required for bidirectionalcommunication following the conventions defined by the NPA protocol.Notes:• Auto is the factory default setting. Auto sets the printer to examine data,determine the format, and then process it appropriately.• The printer automatically restarts when changing the setting from the printercontrol panel. The menu selection is then updated.Understanding the printer menus 64
