|
106 Brocade Adapters Troubleshooting Guide53-1002145-01PHY module data3Displaying authentication settings through BCUUse the BCU auth --show command to display authentication settings.auth --show where:port_id ID of the port for which you want to display authentication settings. This couldbe the PWWN, port hardware path, or user-specified port name. This couldalso be the adapter-index/port-index. For example, to specify adapter 1, port1, you would use 1/1 as the port identification.PHY module dataThe Ethernet PHY module, located in the mezzanine card port hardware, aids in communications toand from the Ethernet LAN. Use the bcu phy --query command to query the PHY module anddetermine attributes, such as the PHY module status, installed firmware version, link partnerauto-negotiation ability, PHY auto-negotiation ability, PMA (physical medium attachment sublayer)and PMD (physical medium dependent sublayer) link status and signal detected, and PCS (physicalcoding sublayer) link status.bcu phy --query where: ID of port for which you want to display data. This could be the PWWN, porthardware path, or user-specified port name. This could also be theadapter-index/port-index. For example, to specify adapter 1, port 1 you woulduse 1/1 as the port identification.QoS settings (HBA)Display Quality of Service (QoS) settings on HBAs and Fabric Adapter ports configured in HBAmode. QoS works in conjunction with the QoS feature on Brocade switches to assign traffic priority(high, medium (default), low) to a given source and destination traffic flow.Determining QoS settings through BCUUse the following commands to deter ming QoS settings:• Use the following BCU command to display QoS enabled status.port --query where:port_id ID of the port for which you want to display settings.• Use the following command to display QoS status and other information for a port.qos --query where:port_id ID of the port for which you want to display settings.
|
