Entering the system Service Tag by using System SetupIf Easy Restore fails to restore the Service Tag, use System Setup to enter the Service Tag.Procedure1. Turn on the system.2. Press F2 to enter System Setup.3. Click Service Tag Settings.4. Enter the Service Tag.Note: You can enter the Service Tag only when the Service Tag field is empty. Ensurethat you enter the correct Service Tag. After the Service Tag is entered, it cannot beupdated or changed.5. Click Ok.6. Import your new or existing iDRAC Enterprise license.For more information, see theIntegrated Dell Remote Access Controller User's Guide atDell.com/idracmanuals.Trusted Platform ModuleTrusted Platform Module (TPM) is a dedicated microprocessor designed to secure hardware byintegrating cryptographic keys into devices. A software can use a Trusted Platform Module toauthenticate hardware devices. As each TPM chip has a unique and secret RSA key burned in as itis produced, it can perform the platform authentication.CAUTION Do not attempt to remove the Trusted Platform Module (TPM) from the systemboard. After the TPM is installed, it is cryptographically bound to that specific system board.Any attempt to remove an installed TPM breaks the cryptographic binding, and it cannot bere-installed or installed on another system board.Note: This is a Field Replaceable Unit (FRU). Removal and installation procedures must beperformed only by Dell certified service technicians.Installing the Trusted Platform ModuleBefore you beginCAUTION Many repairs may only be done by a certified service technician. You should onlyperform troubleshooting and simple repairs as authorized in your product documentation, or asdirected by the online or telephone service and support team. Damage due to servicing that isnot authorized by Dell is not covered by your warranty. Read and follow the safety instructionsthat are shipped with your product.1. Follow the safety guidelines listed in the Safety instructions section.2. Follow the procedure listed in the Before working inside your system section.Procedure1. Locate the TPM connector on the system board.Note: To locate the TPM connector on the system board, see the System boardconnectors section.Installing and removing system components188 Dell PowerEdge R430 Owner's Manual
