Options to manage the pre-operating system applicationsYour system has the following options to manage the pre-operating system applications:l System Setupl Boot Managerl Dell Lifecycle Controllerl Preboot Execution Environment (PXE)System SetupBy using the System Setup screen, you can configure the BIOS settings, iDRAC settings, anddevice settings of your system.Note: Help text for the selected field is displayed in the graphical browser by default. To viewthe help text in the text browser, press F1.You can access system setup by using two methods:l Standard graphical browser — The browser is enabled by default.l Text browser — The browser is enabled by using Console Redirection.Viewing System SetupTo view the System Setup screen, perform the following steps:Procedure1. Turn on, or restart your system.2. Press F2 immediately after you see the following message:F2 = System SetupNote: If your operating system begins to load before you press F2, wait for the systemto finish booting, and then restart your system and try again.System Setup detailsThe System Setup Main Menu screen details are explained as follows:OptionDescriptionSystem BIOSEnables you to configure BIOS settings.iDRAC SettingsEnables you to configure iDRAC settings.The iDRAC settings utility is an interface to set up and configure the iDRAC parameters byusing UEFI (Unified Extensible Firmware Interface). You can enable or disable various iDRACparameters by using the iDRAC settings utility. For more information about this utility, seeIntegrated Dell Remote Access Controller User’s Guide at Dell.com/idracmanuals.Pre-operating system management applications56 Dell PowerEdge R430 Owner's Manual