1. Click iDRAC Settings > Thermal.2. Under SYSTEM THERMAL PROFILE > Thermal Profile, select one of the following options:l Default Thermal Profile Settingsl Maximum Performance (Performance Optimized)l Minimum Power (Performance per Watt Optimized)3. Under USER COOLING OPTIONS, set the Fan Speed Offset, Minimum Fan Speed, andCustom Minimum Fan Speed.4. Click Back > Finish > Yes.Device SettingsDevice Settings enables you to configure device parameters.Dell Lifecycle ControllerDell Lifecycle Controller (LC) provides advanced embedded systems management capabilitiesincluding system deployment, configuration, update, maintenance, and diagnosis. LC is deliveredas part of the iDRAC out-of-band solution and Dell system embedded Unified Extensible FirmwareInterface (UEFI) applications.Embedded system managementThe Dell Lifecycle Controller provides advanced embedded systems management throughout thesystem’s lifecycle. The Dell Lifecycle Controller can be started during the boot sequence and canfunction independently of the operating system.Note: Certain platform configurations may not support the full set of features provided by theDell Lifecycle Controller.For more information about setting up the Dell Lifecycle Controller, configuring hardware andfirmware, and deploying the operating system, see the Dell Lifecycle Controller documentation atDell.com/idracmanuals.Boot ManagerThe Boot Manager screen enables you to select boot options and diagnostic utilities.Viewing Boot ManagerTo enter Boot Manager:Procedure1. Turn on, or restart your system.2. Press F11 when you see the following message:F11 = Boot ManagerIf your operating system begins to load before you press F11, allow the system to completethe booting, and then restart your system and try again.Pre-operating system management applicationsDell PowerEdge R430 Owner's Manual 81