Option DescriptionOption DescriptionCapacity Specifies the total capacity of the drive. This field is undefined for removable mediadevices such as optical drives.Boot SettingsYou can use the Boot Settings screen to set the boot mode to BIOS and to specify the boot order.Viewing Boot SettingsTo view the Boot Settings screen, perform the following steps:1 Turn on, or restart your system.2 Press F2 immediately after you see the following message:F2 = System SetupNOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and thenrestart your system and try again.3 On the System Setup Main Menu screen, click System BIOS.4 On the System BIOS screen, click Boot Settings.Boot Settings detailsThe Boot Settings screen provides the following options.Option DescriptionBoot Mode Enables you to set the boot mode of the system.CAUTION: Switching the boot mode may prevent the system from booting if the operating system is notinstalled in the same boot mode.Boot SequenceRetryEnables or disables the Boot Sequence Retry feature. If this option is set to Enabled and the system fails to boot,the system re-attempts the boot sequence after 30 seconds. This option is set to Enabled by default.Hard-Disk Failover Specifies the drive that is booted in the event of a drive failure. The devices are selected in the Hard-Disk DriveSequence on the Boot Option Setting menu. When this option is set to Disabled, only the first drive in the list isattempted to boot. When this option is set to Enabled, all drives are attempted to boot in the order selected in theHard-Disk Drive Sequence. This option is set to Disabled by default.Generic USB boot Enables or disables generic USB boot.Hard-disk DrivePlaceholderEnables or disables Hard-disk Drive Placeholder.BIOS Boot Settings Enables or disables BIOS boot options.NOTE: This option is enabled only if the boot mode is BIOS.38 Pre-operating system management applications
