Figure 59. Removing the power distribution boardNext step1 Install the power distribution board.Installing the power distribution boardPrerequisites1 Follow the safety guidelines listed in Safety instructions2 Follow the procedures in Before working inside your systemSteps1 Align the power distribution board (PDB) with the standoffs on the system.2 Using a Philips #2 screwdriver, tighten the screws that secure the PDB to the system.3 Connect the cables to the system board and the drive backplane.NOTE: Route the cable properly when you replace it to prevent the cable from being pinched or crimped.Figure 60. Installing the power distribution boardDisassembly and reassembly 89
