Steps1 Route the control panel cable through the side wall and the guide slots in the system and connect it to the system board.NOTE: Route the cable properly to prevent the cable from being pinched or crimped.2 Align and insert the left control panel assembly in the slot on the system.3 Using the appropriate screwdriver, tighten the screws that secure the left control panel.Figure 66. Installing the left control panelNext step1 Follow the procedures in After working inside your systemRemoving the right control panelPrerequisites1 Follow the safety guidelines listed in Safety instructions2 Follow the procedures in Before working inside your systemSteps1 Disconnect the control panel cable from the connector on the system board.NOTE: Observe the routing of the cable as you remove it from the system.2 Using the appropriate screwdriver, remove the screws that secure the right control panel.3 Hold the right control panel assembly and remove it from the system.96 Disassembly and reassembly
