Wide Name/Media Access Control (WWN/MAC) addresses to Fibre Channel and Ethernet devices. Chassis assigned WWN/MACaddresses are globally unique and specific to a server slot.Viewing FlexAddress Activation StatusA Feature Card contains one or more of the following features: FlexAddress, FlexAddress Plus, and/or Extended Storage.To view the chassis FlexAddress status using the CMC web interface, click Chassis Overview → Setup.The General Chassis Settings page is displayed.The FlexAddress has a value Active or Not Active. The value Active indicates that the feature is installed on the chassis and NotActive indicates that the feature is not installed and not in use on the chassis.Run the following RACADM command to view the SD feature card status:racadm featurecard -sThe following message is displayed:Active CMC:The feature card inserted is valid, serial number CN0H871T1374036T00MXA00The feature card contains the following feature(s)FlexAddress: boundFlexAddressPlus: boundExtendedStorage: boundStandby CMC:The feature card contains the following feature(s)ExtendedStorage: boundNOTE: The secondary CMC is optional and the output for the standby CMC is displayed only if the standby CMC isavailable in the chassis.Table 34. Status Messages Returned by the featurecard -s CommandStatus Message ActionsNo feature card inserted. Check CMC to verify that the SD card was properlyinserted. In a redundant CMC configuration, ensure that theCMC with the SD feature card installed is the active CMCand not the standby CMC.The feature card inserted is valid and containsthe following feature(s) FlexAddress: bound.No action required.The feature card inserted is valid and containsthe following feature(s) FlexAddress: bound toanother chassis, svctag=ABC1234, SD card SN =1122334455.Remove the SD card; locate and install the SD card for thecurrent chassis.The feature card inserted is valid and containsthe following feature(s) FlexAddress: not bound.The feature card can be moved to another chassis or canbe reactivated on the current chassis. To reactivate on thecurrent chassis, enter racadm racreset until the CMCmodule with the feature card installed becomes active.Use the following RACADM command to display all activated features on the chassis:racadm feature -sThe command returns the following status message:Feature Name = FlexAddressDate/time Activated = 05 Oct 2013 - 11:50:49Feature installed from SD-card serial number = CN0H871T1374036T00MXA00Feature Name = FlexAddressPlusDate/time Activated = 05 Oct 2013 - 11:50:49Feature installed from SD-card serial number = CN0H871T1374036T00MXA00Feature Name = ExtendedStorage144
