Configuring Initial CMC NetworkNOTE: Changing your CMC Network settings may disconnect your current network connection.You can perform the initial network configuration of CMC before or after CMC has an IP address. If you configure CMC’s initialnetwork settings before you have an IP address, you can use either of the following interfaces:• The LCD panel on the front of the chassis• Dell CMC serial consoleIf you configure initial network settings after the CMC has an IP address, you can use any of the following interfaces:• Command line interfaces (CLIs) such as a serial console, Telnet, SSH, or the Dell CMC console.• Remote RACADM• CMC web interface• LCD Panel interfaceCMC supports both IPv4 and IPv6 addressing modes. The configuration settings for IPv4 and IPv6 are independent of each other.Configuring CMC Network Using LCD Panel InterfaceYou can use the LCD panel interface to set up the CMC network.NOTE: You can customize the orientation of an LCD display (for rack or tower mode) by keeping the up-down buttonspressed for two seconds. Alternately, you can also use the right-left buttons. For more information about the buttonsavailable on a CMC LCD panel, see LCD Navigation.1. To start the CMC configuration:• For a chassis that has not been configured earlier, the LCD Language panel is displayed. On the LCD Language panel,navigate to the required language using the arrow buttons. When the desired language is highlighted, select the language bypressing the Center button. The Network Settings panel is displayed.• For a chassis that has been configured earlier, the Main Menu panel is displayed. From the Main Menu, select Settings andthen Network Settings.2. On the Network Settings panel, select the required mode of setup:• Quick Setup (DHCP) — Select this mode to set up CMC quickly using DHCP addresses. For information on configuringCMC using this mode see Configuring CMC Using Quick Setup (DHCP).• Advanced Setup — Select this mode to set up CMC for advanced configurations. For information on configuring CMCusing this mode see Configuring CMC Using Advanced Setup.Configuring CMC Using Quick Setup (DHCP)To set up a network using the LCD panel interface:1. From the Network Settings panel, select Quick Setup (DHCP). The panel displays the following message.About to get DHCP addresses. Ensure CMC network cable is connected.2. Press the center button to highlight the accept button. Press the center button again to accept the settings or navigate to theback arrow and the press the center button to go back and modify the settings.Configuring CMC Using Advanced Setup1. On the Network Settings panel, if you select Advanced Setup, the following message is displayed to confirm if want toconfigure CMC:Configure CMC?2. To configure CMC by using advanced setup properties, click the center button selecting the check icon.NOTE: To skip the CMC configuration navigate to the ‘X’ icon and then press the center button.3. If you are asked to select an appropriate network speed, select a network speed (Auto (1Gb), 10Mb, or 100Mb) usingappropriate buttons.29
