• 0 — not blinking (default)• 1 — blinkingracadm raid <operation> FQDD>, where the operation value is blink or unblink, and the FQDD is forthe component's physical disk drive, virtual disk and enclosures.Configuring CMC PropertiesYou can configure CMC properties such as power budgeting, network settings, users, and SNMP and email alerts using the webinterface or RACADM commands.Configuring iDRAC Launch Method Using CMC Web InterfaceTo configure the iDRAC launch method from the General Chassis Settings page:1. In the left pane, click Chassis Overview → Setup.The General Chassis Settings page is displayed.2. In the drop-down menu for the iDRAC Launch Method property, select IP Address or DNS.3. Click Apply.NOTE: A DNS-based launch is used for any particular iDRAC only if:• The chassis setting is DNS.• CMC has detected that the specific iDRAC is configured with a DNS name.Configuring iDRAC Launch Method Using RACADMTo update CMC firmware using RACADM, use the cfgRacTuneIdracDNSLaunchEnable subcommand. For more information,see the Chassis Management Controller for PowerEdge VRTX RACADM Command Line Reference Guide available at dell.com/support/manuals.Configuring Login Lockout Policy Attributes Using CMC Web InterfaceNOTE: To perform the following tasks, you must have Chassis Configuration Administrator privilege.The Log in Security enables you to configure the IP range attributes for CMC login using the CMC web interface. To configure theIP range attributes using CMC web interface:1. In the left pane, go to Chassis Overview and click Network → Network.The Network Configuration page is displayed.2. In the IPv4 Settings section, click Advanced Settings. Alternatively, to access the Log in Security page, in the left pane, go toChassis Overview, click Security → Log in.The Log in Security page is displayed.3. To enable the user blocking or IP blocking feature, in the Login Lockout Policy section, select Lockout by User Name orLockout by IP Address (IPV4) .The options to set the other login lockout policy attributes are activated.4. Enter the required values for login lockout policy attributes in the activated fields — Lockout Fail Count, Lockout Fail Window ,and Lockout Penalty Time. For more information, see the CMC Online Help.5. To save these settings, click Apply.Configuring Login Lockout Policy Attributes Using RACADMYou can use RACADM to configure the Login lockout policy attributes for the following features:• User blocking35
