|
For more information, see the Chassis Management Controller for PowerEdge VRTX RACADM Command Line Reference Guide.Creating Virtual Disk Using CMC Web InterfaceBy default, CMC creates virtual disks without initializing them. However, you can choose the fast-initialization option for virtual disksthat are created without initialization. The fast-initialization process clears the first and last 8 MB of the virtual disk, deleting all bootrecords or partition information. You must have the Chassis Configuration Administrator privilege to perform fast-initialization.Make sure that the physical disk is installed in the chassis.NOTE: Deleting a virtual disk removes the virtual disk from the controller's configuration.To create a virtual disk:1. In the left pane, click Chassis Overview → Storage → Virtual Disks → Create.2. On the Create Virtual Disk page, from the RAID Level section, select the RAID level.3. From the Select Physical Disks section, select the number of physical disk drives based on the RAID level selected.4. In the Configure Settings section, type appropriate data, select the Initialize and Encrypt Virtual Disk options, and then clickCreate Virtual Disk.CMC provides a new option, initialization, while creating virtual disks. This option allows you to create a virtual disk without fastinitialization. By default, the virtual disk is created with fast initialization.The Initialize option allows you to create virtual disks without initialization. This option overrides the default behavior where afast initialization process starts when a virtual disk is created.The Encrypt Virtual Disk option allows you to create secure virtual disks on Self-Encryption Drives (SEDs).NOTE: The Encrypt Virtual Disk option is enabled only if the encryption key is configured for the specific controller,on the Controller Settings page.Managing Encryption KeysAn encryption or security key, created on a controller, is used to lock or unlock access to secure virtual disks created on SEDs. Youcan create only one encryption key for an encryption-capable controller. You can create encryption keys by entering an encryptionkey identifier and passphrase, on the Controller Setup page. CMC also allows you to modify encryption key passphrases and deleteencryption keys.Creating Encryption Key Using CMC Web InterfaceYou can create encryption or security keys for controllers if the encryption key is Unconfigured.To create an encryption key:1. In the left pane, go to Storage → Controllers → Setup.2. From the Security Key drop-down, select Create Security Key.A pop-up window is displayed.3. Enter the security key and password and click OK.4. On the Controller Setup page, click Apply.Once the encryption key is created, the status of the Security Key changes to Enabled.Creating Encryption Key Using RACADMTo create an encryption key by running a RACADM command, use the following syntax:racadm raid createsecuritykey:RAID.ChassisIntegrated.1-1 -key -passwd For more information, see the Chassis Management Controller PowerEdge VRTX RACADM Command Line Reference Guide.176
|
