Enabling PIM-SSMTo enable PIM-SSM, follow these steps.1. Create an ACL that uses permit rules to specify what range of addresses should use SSM.CONFIGURATION modeip access-list standard name2. Enter the ip pim ssm-range command and specify the ACL you created.CONFIGURATION modeip pim ssm-range acl-nameEnabling PIM-SSMTo display address ranges in the PIM-SSM range, use the show ip pim ssm-range command from EXEC Privilege mode.R1(conf)#do show run pim!ip pim rp-address 10.11.12.2 group-address 224.0.0.0/4ip pim ssm-range ssmR1(conf)#do show run acl!ip access-list standard ssmseq 5 permit host 239.0.0.2R1(conf)#do show ip pim ssm-rangeGroup Address / MaskLen239.0.0.2 / 32Use PIM-SSM with IGMP Version 2 HostsPIM-SSM requires receivers that support IGMP version 3. You can employ PIM-SSM even when receivers support only IGMPversion 1 or version 2 by translating (*,G) entries to (S,G) entries.Translate (*,G) entries to (S,G) entries using the ip igmp ssm-map acl command source from CONFIGURATION mode. In astandard access list, specify the groups or the group ranges that you want to map to a source. Then, specify the multicast source.• When an SSM map is in place and Dell Networking OS cannot find any matching access lists for a group, it continues to create(*,G) entries because there is an implicit deny for unspecified groups in the ACL.• When you remove the mapping configuration, Dell Networking OS removes the corresponding (S,G) states that it created andre-establishes the original (*,G) states.• You may enter multiple ssm-map commands for different access lists. You may also enter multiple ssm-map commands for thesame access list, as long as they use different source addresses.• When an extended ACL is associated with this command, Dell Networking OS displays an error message. If you apply anextended ACL before you create it, Dell Networking OS accepts the configuration, but when the ACL is later defined, DellNetworking OS ignores the ACL and the stated mapping has no effect.To display the source to which a group is mapped, use the show ip igmp ssm-map [group] command. If you use the groupoption, the command displays the group-to-source mapping even if the group is not currently in the IGMP group table. If you do notspecify the group option, the display is a list of groups currently in the IGMP group table that has a group-to-source mapping.To display the list of sources mapped to a group currently in the IGMP group table, use the show ip igmp groups groupdetail command.Configuring PIM-SSM with IGMPv2R1(conf)#do show run pim!PIM Source-Specific Mode (PIM-SSM) 541
