6. The Z9000 boots up with the factory default configuration. The default Dell Networking OS system prompt displays when thesystem boot up is complete.NOTE: Do not press any keys during the boot-up process.7. Copy the startup-config into the running-config.EXEC Privilege modecopy flash://startup-config running-config8. Display the content of the startup-config.EXEC Privilege modeshow running-config9. Remove the previous authentication configuration.config t10. Set the new authentication parameters. The remainder of the previous configuration is preserved.no enable passwordenable password [newpassword]exit11. Save the running-config to the startup-config in flash by default.write-mem12. Save the running-config.EXEC Privilege modecopy running-config startup-configRecovering from a Forgotten Enable Password on the Z9000Use the following commands if you forget the enable password.1. Log onto the system using the console.2. Power-cycle the chassis by switching off all of the power modules and then switching them back on.3. Press any key to abort the boot process. You enter grub on the Z9000, as indicated by the grub> prompt.(during bootup)hit any keyNOTE: You must enter the CLI commands. The system rejects them if they are copied and pasted.4. The Grub menu displays. Enter c to get to the Grub boot load command line grub> prompt.5. Set the system parameters to ignore the enable password when the system reloads and save the environment.uBoot modegrub>setenv enablepwdignore=truegrub>save_env enablepwdignore6. Reload the system.uBoot modereset7. Configure a new enable password.CONFIGURATION modeenable {secret | password}68 Management
