Track 3IPv6 route 2050::/64 reachabilityReachability is Up (STATIC)5 changes, last change 00:02:16First-hop interface is TenGigabitEthernet 1/3Tracked by:VRRP TenGigabitEthernet 1/8 IPv6 VRID 1The following example shows verifying the VRRP status.Dell#show vrrp------------------TenGigabitEthernet 1/8, IPv6 VRID: 1, Version: 3, Net: fe80::201:e8ff:fe01:95ccVRF: 0 default-vrfState: Master, Priority: 100, Master: fe80::201:e8ff:fe01:95cc (local)Hold Down: 0 centisec, Preempt: TRUE, AdvInt: 100 centisecAccept Mode: FALSE, Master AdvInt: 100 centisecAdv rcvd: 0, Bad pkts rcvd: 0, Adv sent: 310Virtual MAC address:00:00:5e:00:02:01Virtual IP address:2007::1 fe80::1Tracking states for 2 resource Ids:2 - Up IPv6 route, 2040::/64, priority-cost 20, 00:02:113 - Up IPv6 route, 2050::/64, priority-cost 30, 00:02:11The following example shows verifying the VRRP configuration on an interface.Dell#show running-config interface tengigabitethernet 1/8interface TenGigabitEthernet 1/8no ip addressipv6 address 2007::30/64vrrp-ipv6-group 1track 2 priority-cost 20track 3 priority-cost 30virtual-address 2007::1virtual-address fe80::1no shutdownSetting VRRP Initialization DelayWhen configured, VRRP is enabled immediately upon system reload or boot. You can delay VRRP initialization to allow the IGP andEGP protocols to be enabled prior to selecting the VRRP Master. This delay ensures that VRRP initializes with no errors or conflicts.You can configure the delay for up to 15 minutes, after which VRRP enables normally.NOTE: When you reload a node that contains VRRP configuration and is enabled for VLT, Dell Networking recommendsthat you configure the reload timer by using the vrrp delay reload command to ensure that VRRP is functional.Otherwise, when you reload a VLT node configured for VRRP, the local destination address is not seen on the reloadednode causing suboptimal routing.Set the delay timer on individual interfaces. The delay timer is supported on all physical interfaces, VLANs, and LAGs.When you configure both CLIs, the later timer rules VRRP enabling. For example, if you set vrrp delay reload 600 and vrrpdelay minimum 300, the following behavior occurs:• When the system reloads, VRRP waits 600 seconds (10 minutes) to bring up VRRP on all interfaces that are up and configuredfor VRRP.• When an interface comes up and becomes operational, the system waits 300 seconds (5 minutes) to bring up VRRP on thatinterface.To set the delay time for VRRP initialization, use the following commands.• Set the delay time for VRRP initialization on an individual interface.806 Virtual Router Redundancy Protocol (VRRP)
