MIB Object OID Values Description2 = copy in progress3 = disk full4 = file exists5 = file not found6 = timeout7 = unknowncopyEntryRowStatus .1.3.6.1.4.1.6027.3.5.1.1.1.1.15 Row status Specifies the state of the copyoperation. Uses CreateAndGowhen you are performing thecopy. The state is set to activewhen the copy is completed.Obtaining a Value for MIB ObjectsTo obtain a value for any of the MIB objects, use the following command.• Get a copy-config MIB object value.snmpset -v 2c -c public -m ./f10-copy-config.mib force10system-ip-address [OID.index |mib-object.index]index: the index value used in the snmpset command used to complete the copy operation.NOTE: You can use the entire OID rather than the object name. Use the form: OID.index.Examples of Getting MIB Object ValuesThe following examples show the snmpget command to obtain a MIB object value. These examples assume that:• the server OS is UNIX• you are using SNMP version 2c• the community name is public• the file f10-copy-config.mib is in the current directoryNOTE: In UNIX, enter the snmpset command for help using this command.The following examples show the command syntax using MIB object names and the same command using the object OIDs. In bothcases, the same index number used in the snmpset command follows the object.The following command shows how to get a MIB object value using the object name.> snmpget -v 2c -c private -m ./f10-copy-config.mib 10.11.131.140 copyTimeCompleted.110FTOS-COPY-CONFIG-MIB::copyTimeCompleted.110 = Timeticks: (1179831) 3:16:38.31The following command shows how to get a MIB object value using OID.> snmpget -v 2c -c private 10.11.131.140 .1.3.6.1.4.1.6027.3.5.1.1.1.1.13.110SNMPv2-SMI::enterprises.6027.3.5.1.1.1.1.13.110 = Timeticks: (1179831) 3:16:38.31Simple Network Management Protocol (SNMP) 701
