Console logging: level DebuggingMonitor logging: level DebuggingBuffer logging: level Debugging, 40 Messages Logged, Size (40960 bytes)Trap logging: level Informational%IRC-6-IRC_COMMUP: Link to peer RPM is up%RAM-6-RAM_TASK: RPM1 is transitioning to Primary RPM.%RPM-2-MSG:CP1 %POLLMGR-2-MMC_STATE: External flash disk missing in 'slot0:'%CHMGR-5-CARDDETECTED: Line card 0 present%CHMGR-5-CARDDETECTED: Line card 2 present%CHMGR-5-CARDDETECTED: Line card 4 present%CHMGR-5-CARDDETECTED: Line card 5 present%CHMGR-5-CARDDETECTED: Line card 8 present%CHMGR-5-CARDDETECTED: Line card 10 present%CHMGR-5-CARDDETECTED: Line card 12 present%TSM-6-SFM_DISCOVERY: Found SFM 0%TSM-6-SFM_DISCOVERY: Found SFM 1%TSM-6-SFM_DISCOVERY: Found SFM 2%TSM-6-SFM_DISCOVERY: Found SFM 3%TSM-6-SFM_DISCOVERY: Found SFM 4%TSM-6-SFM_DISCOVERY: Found SFM 5%TSM-6-SFM_DISCOVERY: Found SFM 6%TSM-6-SFM_DISCOVERY: Found SFM 7%TSM-6-SFM_SWITCHFAB_STATE: Switch Fabric: UP%TSM-6-SFM_DISCOVERY: Found SFM 8%TSM-6-SFM_DISCOVERY: Found 9 SFMs%CHMGR-5-CHECKIN: Checkin from line card 5 (type EX1YB, 1 ports)%TSM-6-PORT_CONFIG: Port link status for LC 5 => portpipe 0: OK portpipe 1: N/A%CHMGR-5-LINECARDUP: Line card 5 is up%CHMGR-5-CHECKIN: Checkin from line card 12 (type S12YC12, 12 ports)%TSM-6-PORT_CONFIG: Port link status for LC 12 => portpipe 0: OK portpipe 1: N/A%CHMGR-5-LINECARDUP: Line card 12 is up%IFMGR-5-CSTATE_UP: changed interface Physical state to up: So 12/8%IFMGR-5-CSTATE_DN: changed interface Physical state to down: So 12/8To view any changes made, use the show running-config logging command in EXEC privilege mode, as shown in theexample for Configure a UNIX Logging Facility Level .Configuring a UNIX Logging Facility LevelYou can save system log messages with a UNIX system logging facility.To configure a UNIX logging facility level, use the following command.• Specify one of the following parameters.CONFIGURATION modelogging facility [facility-type]– auth (for authorization messages)– cron (for system scheduler messages)– daemon (for system daemons)– kern (for kernel messages)– local0 (for local use)– local1 (for local use)– local2 (for local use)– local3 (for local use)– local4 (for local use)– local5 (for local use)– local6 (for local use)– local7 (for local use)60 Management
