dot1x server-timeout secondsThe range is from 1 to 300.The default is 30.Example of Viewing Configured Server TimeoutsThe example shows configuration information for a port for which the authenticator terminates the authentication process for anunresponsive supplicant or server after 15 seconds.The bold lines show the new supplicant and server timeouts.Dell(conf-if-Te-1/1)#dot1x port-control force-authorizedDell(conf-if-Te-1/1)#do show dot1x interface TenGigabitEthernet 1/1802.1x information on Te 1/1:-----------------------------Dot1x Status: EnablePort Control: FORCE_AUTHORIZEDPort Auth Status: UNAUTHORIZEDRe-Authentication: DisableUntagged VLAN id: NoneGuest VLAN: DisableGuest VLAN id: NONEAuth-Fail VLAN: DisableAuth-Fail VLAN id: NONEAuth-Fail Max-Attempts: NONETx Period: 90 secondsQuiet Period: 120 secondsReAuth Max: 10Supplicant Timeout: 15 secondsServer Timeout: 15 secondsRe-Auth Interval: 7200 secondsMax-EAP-Req: 10Auth Type: SINGLE_HOSTAuth PAE State: InitializeBackend State: InitializeEnter the tasks the user should do after finishing this task (optional).Configuring Dynamic VLAN Assignment with Port AuthenticationDell Networking OS supports dynamic VLAN assignment when using 802.1X.The basis for VLAN assignment is RADIUS attribute 81, Tunnel-Private-Group-ID. Dynamic VLAN assignment uses the standarddot1x procedure:1. The host sends a dot1x packet to the Dell Networking system2. The system forwards a RADIUS REQEST packet containing the host MAC address and ingress port number3. The RADIUS server authenticates the request and returns a RADIUS ACCEPT message with the VLAN assignment usingTunnel-Private-Group-IDThe illustration shows the configuration on the Dell Networking system before connecting the end user device in black and blue text,and after connecting the device in red text. The blue text corresponds to the preceding numbered steps on dynamic VLANassignment with 802.1X.802.1X 81
