1656 System Management Commands! Prefer the RJ45 port and leave the SFP port poweredonconsole(config-if-Te1/0/24)#media-type auto-selectrj45memberUse the member command in Stack Global Configuration mode to pre-configure a switch stack member. Execute this command on the ManagementSwitch. To remove a stack-member configuration from the stack, use the noform of the command.The no form of the command may not be used if the member is present in the stack.Syntaxmemberunit switchindexno memberunit•unit — The switch identifier of the switch to be added or removed fromthe stack. (Range: 1–12)•switchindex — The index into the database of the supported switch types,indicating the type of the switch being preconfigured. The switch index isa 32-bit integer obtained from the show supported switchtype command.Default configurationThis command has no defaults.Command ModeStack Global ConfigurationUser GuidelinesThe switch index (SID) can be obtained by executing the show supportedswitchtype command in User Exec mode. When removing a unit from astack, use the no member command to remove the stack memberconfiguration after physically removing the unit.
