654 Port Monitor Commandsmonitor sessionUse the monitor session command in Global Configuration mode toconfigure a probe port and a monitored port for monitor session (portmonitoring). Use the src-interface parameter to specify the interface tomonitor. Use rx to monitor only ingress packets, or use tx to monitor onlyegress packets. If you do not specify an {rx | tx} option, the destination portmonitors both ingress and egress packets. Use the destination interface tospecify the interface to receive the monitored traffic. Use the mode parameterto enabled the administrative mode of the session. If enabled, the probe portmonitors all the traffic received and transmitted on the physical monitoredport.Use the no form of the command to remove the monitoring session.Syntaxmonitor sessionsession_number {source interfaceinterface–id [rx | tx] |destination interfaceinterface–id}no monitor session•session _number— Session identification number.• interface–id — Ethernet interface (Range: Any valid Ethernet Port), CPUinterface. CPU interface is not supported as a destination interface.• rx — Monitors received packets only. If no option specified, monitors bothrx and tx.• tx — Monitors transmitted packets only. If no option is specified, monitorsboth rx and tx.• Use the mode keyword to enable the session monitoring.Default ConfigurationMonitor sessions are not enabled by default.Command ModeGlobal Configuration modemonitor session show monitor session
