Sflow Commands 1511User GuidelinesThis command has no user guidelines.Exampleconsole(config-if-1/0/2)#sflow 1 polling 6055sflow samplingUse the sflow sampling command to enable a new sflow sampler instance forthis data source if rcvr_idx is valid. Use the “no” form of this command toreset sampler parameters to the default.Syntaxsflowrcvr-index sampling {gigabitethernet | tengigabitethernet}interfac-list sampling-rate [size]no sflowrcvr-index sampling {gigabitethernet | tengigabitethernet}interface-list•rcvr-index— The sFlow Receiver for this sFlow sampler to which flowsamples are to be sent. If no receiver is configured, then no packets will besampled. Only active receivers can be set. If a receiver expires, then allsamplers associated with the receiver will also expire. (Range: 1–8).•interface-list — The list of interfaces to poll in unit/slot/port format.•sampling-rate— The statistical sampling rate for packet sampling from thissource. A sampling rate of 1 counts all packets. A rate of 0 disablessampling. A value of n means that out of n incoming packets, 1 packet willbe sampled. (Range: 1024–65536).•size—The maximum number of bytes that should be copied from thesampler packet (Range: 20–256 bytes).Default ConfigurationThere are no samplers configured by default.The default sampling rate is 0.The default maximum header size is 128.
