Dell PowerConnect 7000 Series Reference Manual

Also see for PowerConnect 7000 Series: Stacking instructions Technical white paper

Contents

Dell PowerConnect 7000 Series Reference Manual Manual pdf 773 page image

VLAN Commands 773Default ConfigurationThe default for this command is 802.1Q. The default S-TAG TPID, whendouble-tagging is enabled, is 0x88A8. The default C-TAG TPID when doublevlan tagging is enabled is 0x8100.Command ModeGlobal Configuration, Interface Configuration modeUser GuidelinesThis command configures the TPID value on the outer VLAN (S-VLAN).The global configuration form of the command configures all physical andport-channel interfaces to use the specified ethertype. The interface form ofthe command enables/disables the use of the ethertype on the specificinterface. The ethertype used in the interface form of the command must usethe same ethertype as specified in the global configuration form of thecommand. The inner vlan tag (C-TAG) is configured using the switchportcommand in interface configuration mode.ExampleThe following example displays configuring Double VLAN tunnel for vmanEtherType.console(config)#dvlan-tunnel ethertype vmaninterface vlanUse the interface vlan command in Global Configuration mode to configurea VLAN type and to enter Interface Configuration mode.Syntaxinterface vlanvlan-idParameter DescriptionParameter Descriptionvlan-id The ID of a valid VLAN (Range: 1–4093).