System Management Commands 1615show switchUse the show switch command in User EXEC mode to display informationabout units in the stack.The show switch command shows the configuration and status of thestacking units, including the active and standby stack management units, thepre-configured model identifier, the plugged in model identifier, the switchstatus and the current code version. If there is a stack firmwaresynchronization (SFS) operation in progress, the switch status will show asUpdating Code. Both the pre-configured switch type (as set by the membercommand in stack mode) and the actual connected switch type are shown.The show switchunitid command shows details of the switch configurationincluding the SFS last attempt status for the specified unit.The show switch command may show an SDM Mismatch value in the SwitchStatus field. This value indicates that the unit joined the stack, but is runninga different SDM template than the management unit. This status should betemporary; the stack unit should automatically reload using the templaterunning on the stack manager.Use the show supported switchtype command to display switch SIDs.Use the show stack-ports command to display details regarding stacking links.Use the show slot command to display details regarding slot configuration.Use the show sdm prefer command to display the SDM templateconfiguration.Syntaxshow switch [chassis-mgmt | stack–member–number | stack–ports[counters| diag] | stack–standby]Parameter DescriptionParameter Descriptionunitid The unit number.chassis-mgmt Display chassis management.
