1034 Configuring VRRPConfiguring VRRP Features (CLI)This section provides information about the commands you use to configureVRRP settings on the switch. For more information about the commands, seethePowerConnect 7000 Series CLI Reference Guide.Configuring VRRP SettingsBeginning in Privileged EXEC mode, use the following commands toconfigure switch and interface VRRP settings. This set of commands alsodescribes how to configure VRRP interface and route tracking.Command Purposeconfigure Enter global configuration mode.ip vrrp Enable the administrative mode of VRRP for the router(L3 switch).interface vlanvlan-id Enter Interface Configuration mode for the specifiedVLAN.vrrpvr-id Allow the interface to create in the VRRP group specifiedby thevr-id parameter, which is a number from 1–255.vrrpvr-id description (Optional) Create a text description that identifies theVRRP group.vrrpvr-id preempt [delayseconds]Enable the preemption mode value for the virtual routerconfigured on a specified interface.You can optionally configure a preempt delay, which is thenumber of seconds the VRRP router waits before theVRRP router sends an advertisement to claim masterownership.vrrpvr-id accept-mode Allow the VRRP Master to accept ping packets sent to oneof the virtual router’s IP addresses.vrrpvr-id priorityprioritySet the priority value for the virtual router configured onthe interface.vrrpvr-id ipip-address[secondary]Set the virtual router IP address value for an interface.
