680 Discovering Network DevicesConfiguring Global LLDP SettingsBeginning in Privileged EXEC mode, use the following commands toconfigure LLDP settings that affect the entire switch.Configuring Port-based LLDP SettingsBeginning in Privileged EXEC mode, use the following commands toconfigure per-port LLDP settings.Command Purposeconfigure Enter Global Configuration mode.lldp notification-intervalintervalSpecify how often, in seconds, the switch should sendremote data change notifications.lldp timers [intervaltransmit-interval] [holdhold-value] [reinitreinit-delay]Configure the timing for local data transmission on portsenabled for LLDP.•transmit-interval — The interval in seconds at which totransmit local data LLDP PDUs. (Range: 5–32768seconds)•hold-value — Multiplier on the transmit interval used toset the TTL in local data LLDP PDUs. (Range: 2–10)•reinit-delay — The delay in seconds before re-initialization. (Range: 1–10 seconds)exit Exit to Privileged EXEC mode.show lldp View global LLDP settings.Command Purposeconfigure Enter Global Configuration mode.interfaceinterface Enter interface configuration mode for the specifiedEthernet interface.lldp transmit Enable the LLDP advertise (transmit) capability.lldp receive Enable the LLDP receive capability so that the switch canreceive LLDP Protocol Data Units (LLDP PDUs) fromother devices.lldp transmit-mgmt Include the transmission of local system managementaddress information in the LLDP PDUs.
