Monitoring and Logging System Information 259Monitoring System Information and ConfiguringLogging (CLI)This section provides information about the commands you use to configureinformation you use to monitor the PowerConnect 7000 Series switch. Formore information about these commands, see thePowerConnect 7000 SeriesCLI Reference Guide.Viewing System Information and Enabling the Locator LEDBeginning in Privileged EXEC mode, use the following commands to viewsystem health and resource information and to enable the switch locatorLED.Running Cable DiagnosticsBeginning in Privileged EXEC mode, use the following commands to run thecable diagnostic tests.Command Purposeshow system Display various system information.show system power Displays the power supply status.show systemtemperatureDisplays the system temperature and fan status.show memory cpu Displays the total and available RAM space on the switch.show process cpu Displays the CPU utilization for each process currentlyrunning on the switch.locate [switchunit][timetime]Enable the switch locator LED located on the back panelof the switch. Optionally, you can specify the unit toidentify within a switch stack and the length of time thatthe LED blinks.NOTE: Cable diagnostics may give misleading results if green mode is enabledon the port. Disable green mode prior to running any cable diagnostics.
